Teclock Durometer Hardness Tester GS-709N/GS-709G Series

Teclock Durometer Hardness Tester GS-709N/GS-709G Series


Specifications
Details

Teclock Durometer Hardness Tester GS-709 series – corresponding to ISO and JIS standards of rubber hardness measurement by MSP Metrology (M) Sdn Bhd from Teclock Japan.
 

Features

 
 
 

Durometers for Hardness Test of Plastic


This standard is prescribed by plastic industry in Japan apart from testing method of hardness of rubber. This is basically equal to Durometer of JIS K 6253, as only its round up method of spring load value etc. is different. But we distinguish model name as another Durometer according to the view of conformity to standard.




Peak Pointer Type   

Some of Rubbers, Elastomer’ elastic body is not easily read the maximum value after firm contacting with a presser foot of durometer , due to the stress relaxation. The pointer indicates the descendent value but the peak pointer is holding the maximum measured value. The peak pointer type can easily read the maximum value efficiently.

In case the pointer cannot be read directly due to some obstacles altough the measuring can be done, the mesured value can be confirmed from peak pointer after measuring. The upper / lower limiters equipped will be effectively used in tolerance judgment.



 


Specifications

 
Model Type Application/Materials Conform Standard

Spring Load Value (0-100)

Indentor Shape Indentor Height Weight(g)
GS-709N Type A Soft Plastic/General Rubber JIS K 7215
ISO 868
ASTM D 2240
549-8061mN (56-822gf) Truncated Cone of R0.79 with 35° angle 2.50 200
GS-709G Type A Soft Plastic/General Rubber (Peak Pointer Type) Truncated Cone of R0.79 with 35° angle 2.50 208
 

Dimension

 

View more about Teclock Durometer Hardness Tester GS-709N/GS-709G Series on main site